Release notes -
Resolves an issue with low-voltage PV production that some users have reported
Resolves an issue with force discharge not kicking into self-use when reaching the FDSOC level
Site Admin
Community Admin / FoxESS Elite Professional
Did I help you? Feel free to leave me a tip
Book a zoom meeting for remote consultancy or help
Switch to Octopus and earn £50
Subscribe to my YouTube channel
2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1 (Solar Mode)
1 x H1 Gen2 WL (Testing, Modbus and API development)
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
2 x EV's (Tesla & Mercedes)
Heatpump & Low Carbon Housebuild
Did I help you? Feel free to leave me a tip Book a zoom meeting for remote consultancy or help Switch to Octopus and earn £50 Subscribe to my YouTube channel2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1 (Solar Mode)
1 x H1 Gen2 WL (Testing, Modbus and API development)
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
2 x EV's (Tesla & Mercedes)
Heatpump & Low Carbon Housebuild
Hi Will,
I'm still seeing the PV production issue, it now appears that no production is being logged below 250W. Have you seen any improvement at all?
Neil
I'm still seeing the PV production issue, it now appears that no production is being logged below 250W. Have you seen any improvement at all?
Neil
Site Admin
I also seem to still only see proper generation from 200w
Community Admin / FoxESS Elite Professional
Did I help you? Feel free to leave me a tip
Book a zoom meeting for remote consultancy or help
Switch to Octopus and earn £50
Subscribe to my YouTube channel
2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1 (Solar Mode)
1 x H1 Gen2 WL (Testing, Modbus and API development)
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
2 x EV's (Tesla & Mercedes)
Heatpump & Low Carbon Housebuild
Did I help you? Feel free to leave me a tip Book a zoom meeting for remote consultancy or help Switch to Octopus and earn £50 Subscribe to my YouTube channel2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1 (Solar Mode)
1 x H1 Gen2 WL (Testing, Modbus and API development)
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
2 x EV's (Tesla & Mercedes)
Heatpump & Low Carbon Housebuild
"Resolves an issue with force discharge not kicking into self-use when reaching the FDSOC level"
a number of us in Australia are still reporting this issue.
a number of us in Australia are still reporting this issue.
I'm on 1.55 Master and 1.58 ARM now and I'm seeing PV production down in the ~140W range in heavy cloud cover (70-80W on each of two strings). Perhaps it's resolved in this release instead?
@will
Hi will I can report that the self use doesn't work after a firmware upgrade.
I have upgraded but the fdsoc is hit and my inverter goes to grid.
Is there an known issue with this firmware combination for kh10.5's
Manager 1.55
Slave 1.02
Manager 1.58