This may have been answered before, sorry, but has anyone managed to automatically add standing charge to their energy dashboard? Thanks
Site Admin
I have the rates automated but I don't have standing charge sadly. Following this thread incase anyone has any ideas.
Community Admin / FoxESS Elite Professional
Did I help you? Feel free to leave me a tip
Book a zoom meeting for remote consultancy or help
Switch to Octopus and earn £50
Subscribe to my YouTube channel
Fox ESS Tri Inverter Installation
2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
Dual Tesla Household
Heatpump & Low Carbon Housebuild
Did I help you? Feel free to leave me a tip Book a zoom meeting for remote consultancy or help Switch to Octopus and earn £50 Subscribe to my YouTube channelFox ESS Tri Inverter Installation
2 x KH Hybird Inverters (Parallel Mode)
1 x H1 Gen1
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
Dual Tesla Household
Heatpump & Low Carbon Housebuild
Hi.
I have a GLOW IHD (Hildebrand) connected to my Home Assistant MQTT Broker. In HA, I have some sensors (obviously), three of which read the price per kWh (Import & Export) and the standing charge directly from my SMETS2.
Now, assuming that your provider of choice has commissioned your SMETS2 properly (it took E.On about 3 months after I chased them as they "couldn't take readings" OTA!!!), you should be able to mqtt that data into HA.
As for showing that rate in the generic HA Energy page, I'm not sure. But I do suspect you can overlay it in a Grafana set of charts?
I have a GLOW IHD (Hildebrand) connected to my Home Assistant MQTT Broker. In HA, I have some sensors (obviously), three of which read the price per kWh (Import & Export) and the standing charge directly from my SMETS2.
As for showing that rate in the generic HA Energy page, I'm not sure. But I do suspect you can overlay it in a Grafana set of charts?