Good evening,
I have been using both the FoxCloud 2.0 as well as the Energy Stats app in parallel in order to monitor my consumption/load and self-consumption/self-sufficiency.
Lately I noticed that the value for
a) self-sufficiency shown on the landing screen of the Foxcloud app and that shown in the daily breadown differ considerably (71% vs. 83%) and
b) load consumption shown in the FoxCloud app and the same value shown in the Energy Stats app also differ quite a bit (8.8 kwh vs. 5.1kwh).
All values used to be in sync since a few days ago and I haven't made any changes to my setup, so I wonder what may have caused this - and how to fix it.
Thanks for any pointers !
Site Admin
You can really only go by the fox app as ES goes off the openapi which might have changed recently.
Compare with your utility meter to confirm which one is closer to being correct.
Compare with your utility meter to confirm which one is closer to being correct.
Community Admin / FoxESS Elite Professional
Buy me a coffee or Book a zoom meeting for remote consultancy
FoxESS Tri Inverter Installation
2 x KH & 1 x H1
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
Dual Tesla Household
Heatpump & Low Carbon Housebuild
Buy me a coffee or Book a zoom meeting for remote consultancy
FoxESS Tri Inverter Installation
2 x KH & 1 x H1
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
Dual Tesla Household
Heatpump & Low Carbon Housebuild
Thank you Will,
however the values WITHIN the fox app only (landing screen as compared to daily breakdown) shouldn't differ greatly, if at all - right ?
however the values WITHIN the fox app only (landing screen as compared to daily breakdown) shouldn't differ greatly, if at all - right ?