Hi all,
I was just trying to configure my FOX ESS H3-10.0-E for a German grid connection, but in the Safety menu unfortunately I cannot select VDE4105_DE norm. I do however plenty of other options.
Does this mean that the Inverter needs a Firmware upgrade first or am I doing something wrong?
Hope you can help.
Many thanks,
Stefan
Site Admin
Yes, select anything close and then upgrade the firmware and reconfigure correctly post upgrade.
Community Admin / FoxESS Elite Professional
Buy me a coffee or Book a zoom meeting for remote consultancy
FoxESS Tri Inverter Installation
2 x KH & 1 x H1
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
Dual Tesla Household
Heatpump & Low Carbon Housebuild
Buy me a coffee or Book a zoom meeting for remote consultancy
FoxESS Tri Inverter Installation
2 x KH & 1 x H1
24 x HV2600 (62.4kWh)
32 x 490w across 4 arrays
Dual Tesla Household
Heatpump & Low Carbon Housebuild
I found a setting called ARN4105 - that should be the correct one. The manual I have stated the name differently, so I'd say the issue has been resolved. Thanks for helping. 